Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 9American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 51
Page 37
ABSTRACT The successful application of a composite component is dependent on the interface design between the composito part and adjacent components . Usually steel end fittings are used because many connections use threads or splines .
ABSTRACT The successful application of a composite component is dependent on the interface design between the composito part and adjacent components . Usually steel end fittings are used because many connections use threads or splines .
Page 221
Scale effects in fatigue arise from similar sources in mechanical components and welded joints and should therefore be treated in the same manner in design rules , using Eq.7 . 2 . For mechanical components in bending the size exponent ...
Scale effects in fatigue arise from similar sources in mechanical components and welded joints and should therefore be treated in the same manner in design rules , using Eq.7 . 2 . For mechanical components in bending the size exponent ...
Page 381
However , the stresses at both hot spot locations were dominated by the bending component . Published results ( van Delft et al . , 1986 , and Clayton , 1982 ) suggest that the ratio between bending and membrane components is about 3.0 ...
However , the stresses at both hot spot locations were dominated by the bending component . Published results ( van Delft et al . , 1986 , and Clayton , 1982 ) suggest that the ratio between bending and membrane components is about 3.0 ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
SAFETY AND RELIABILITY | 17 |
37 other sections not shown
Other editions - View all
Common terms and phrases
analysis applications axial behaviour bending brace calculated chord combined compared components composite Composite Materials compression concrete connection considered construction corrosion crack critical curve cycles damage determined developed distribution effect element Engineering environment experimental factor failure fatigue fiber Figure finite element force fracture geometry increase indicate influence initial internal laminate length limit load lower Marine material matrix maximum mean measured mechanical method Mode nodes nominal normal observed obtained offshore operation parameters performance pipe plate platform predicted present pressure production properties range ratio reduced reinforcement Research resin resistance seal shear shell shown shows solutions specimens steel stiffener stiffness strain strength stress stress concentration structures surface Table techniques temperature tensile tension thickness thread tube tubular joints weight weld
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 9 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1990 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |