Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 9American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 52
Page 110
Reinforcement corrosion resistance . The combination of steel and sea water has an inherent corrosion potential ... Sea water on one side , air on 110.
Reinforcement corrosion resistance . The combination of steel and sea water has an inherent corrosion potential ... Sea water on one side , air on 110.
Page 119
... sea water mixed concrete is less than that of the fresh water mixed concrete . The lower resistivity of the sea water mixed concrete can be attributed to thechlorides present in concrete mixed with sea water . From Table 6 it can be ...
... sea water mixed concrete is less than that of the fresh water mixed concrete . The lower resistivity of the sea water mixed concrete can be attributed to thechlorides present in concrete mixed with sea water . From Table 6 it can be ...
Page 120
ded in sea water mixed concrete is 1.3 to 1.6 times higher than the steel embedded in fresh water mixed concrete . The corrosion rate of the steel embedded in fresh water mixed concrete with 0.40 water cement ratio is 1.4 to 4 times ...
ded in sea water mixed concrete is 1.3 to 1.6 times higher than the steel embedded in fresh water mixed concrete . The corrosion rate of the steel embedded in fresh water mixed concrete with 0.40 water cement ratio is 1.4 to 4 times ...
Contents
ADVANCED COMPOSITES | 1 |
Probabilistic Aspects of HAZ CTOD Value of Multipass Welded Joint of Steel for Offshore | 5 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
29 other sections not shown
Other editions - View all
Common terms and phrases
analysis applications as-welded ASTM axial load behaviour bending brace calculated chord Composite Materials compressive strength corrosion rate crack growth CTOD cycles damage delamination elastomer Engineering environment epoxy experimental failure fatigue crack fatigue design fatigue strength fatigue tests Figure finite element finite element analysis fracture mechanics fracture toughness geometry increase initial installation interlaminar fracture laminate layers marine matrix maximum mean stress method Mode modulus moisture nodes nominal notch obtained offshore structures optical fiber parameters performance phenolic pipe plate thickness platform pre-load predicted pressure principal stress pultrusion rebar reinforcement resin resistance riser rubber S-N curves sea water seal shear stress shell shown in Fig space frame specimens steel strain stress concentration stress concentration factor stress range surface crack Table techniques tensile strength tension thickness effect thread tube tubular joints values water mixed concrete weight weld toe welded joints yield strength zone