Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 122
Tests were carried out on material with an IIW carbon equivalent within 0.02 % of the agreed maximum and sulphur content within 0.001 % of the production minimum . The specification required that special care taken during welding and ...
Tests were carried out on material with an IIW carbon equivalent within 0.02 % of the agreed maximum and sulphur content within 0.001 % of the production minimum . The specification required that special care taken during welding and ...
Page 183
Welding of the Oseberg Grade I steel at the Construction yards Mechanical properties of the Grade I steel elivered to the Oseberg Project The construction of the Oseberg A and B platform structures have been carried out at more than 20 ...
Welding of the Oseberg Grade I steel at the Construction yards Mechanical properties of the Grade I steel elivered to the Oseberg Project The construction of the Oseberg A and B platform structures have been carried out at more than 20 ...
Page 396
All of the CTOD and wide plate HAZ tests were aimed at the fusion line but some CTOD tests were carried out with the fatigue crack in weld metal near the fusion line . Obviously , even using a ' straight ' sided weld preparation some ...
All of the CTOD and wide plate HAZ tests were aimed at the fusion line but some CTOD tests were carried out with the fatigue crack in weld metal near the fusion line . Obviously , even using a ' straight ' sided weld preparation some ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |