Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 9
The prepreg tape has been molded into composite laminates which have excellent mechanical ties , propergood property retention at 350 ° F and good chemical resistance . resin shows no significant decrease in tensile properties after ...
The prepreg tape has been molded into composite laminates which have excellent mechanical ties , propergood property retention at 350 ° F and good chemical resistance . resin shows no significant decrease in tensile properties after ...
Page 11
In addition , it has been shown that the PAS - 2 resin has exceptional chemical resistance for amorphous polymer . This added chemical resistance results in good solvent and fuel resistance for PAS - 2 composites for hostile ...
In addition , it has been shown that the PAS - 2 resin has exceptional chemical resistance for amorphous polymer . This added chemical resistance results in good solvent and fuel resistance for PAS - 2 composites for hostile ...
Page 99
Table 3 Chemical compositions of developed steel plates ( wt % ) 0.003 0.034 1.450.007 0.002 0.027 THE POTENTIAL DUAL ... 0.34 0.14 Design Concept of Chemical Composition and TMCP Table 4 Mechanical properties of developed steel plates ...
Table 3 Chemical compositions of developed steel plates ( wt % ) 0.003 0.034 1.450.007 0.002 0.027 THE POTENTIAL DUAL ... 0.34 0.14 Design Concept of Chemical Composition and TMCP Table 4 Mechanical properties of developed steel plates ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |