Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 59
Page 261
It should also be pointed out that for the 30 % coarse grained welding procedures a difference in behaviour was noted between test temperatures of -30 ° C and + 10 ° C . The former temperature produced complete fractures of the test ...
It should also be pointed out that for the 30 % coarse grained welding procedures a difference in behaviour was noted between test temperatures of -30 ° C and + 10 ° C . The former temperature produced complete fractures of the test ...
Page 279
The aim was to position the notch tip in the coarse grained zone , but especially for the SMAW weldments it was difficult to hit this zone at the prescribed depth of 3 mm , and only a few SMAW specimens had the notch positioned in the ...
The aim was to position the notch tip in the coarse grained zone , but especially for the SMAW weldments it was difficult to hit this zone at the prescribed depth of 3 mm , and only a few SMAW specimens had the notch positioned in the ...
Page 387
ABSTRACT K W stress intensity factor plate width tension stress 0 INTRODUCTION The principal objective of this study was to evaluate coarse grained HAZ toughness of the steels for offshore structure use . For that purpose , wide plate ...
ABSTRACT K W stress intensity factor plate width tension stress 0 INTRODUCTION The principal objective of this study was to evaluate coarse grained HAZ toughness of the steels for offshore structure use . For that purpose , wide plate ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |