Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 80
Page 99
Table 3 Chemical compositions of developed steel plates ( wt % ) 0.003 0.034 1.450.007 0.002 0.027 THE POTENTIAL DUAL ... 0.34 0.14 Design Concept of Chemical Composition and TMCP Table 4 Mechanical properties of developed steel plates ...
Table 3 Chemical compositions of developed steel plates ( wt % ) 0.003 0.034 1.450.007 0.002 0.027 THE POTENTIAL DUAL ... 0.34 0.14 Design Concept of Chemical Composition and TMCP Table 4 Mechanical properties of developed steel plates ...
Page 520
Each alloying element was added to or removed from the base composition at 3 4 levels . Chemical composition of the base steel and the range of each alloying element varied are shown in Table 1. Simulated thermal cycles were double with ...
Each alloying element was added to or removed from the base composition at 3 4 levels . Chemical composition of the base steel and the range of each alloying element varied are shown in Table 1. Simulated thermal cycles were double with ...
Page 535
The effects of variations in composition of shielding gas in Gas Metal Arc Welding of duplex stainless steel on the mechanical properties and corrosion resistance of weld deposits have been investigated and the following conclusions ...
The effects of variations in composition of shielding gas in Gas Metal Arc Welding of duplex stainless steel on the mechanical properties and corrosion resistance of weld deposits have been investigated and the following conclusions ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |