## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |

### From inside the book

Results 1-3 of 77

Page 362

The method includes ( 1 ) development of equivalent S - N

development of a relationship between the ...

) calculation of fatigue life using the conventional S - N approach . where a is the

crack ...

The method includes ( 1 ) development of equivalent S - N

**curves**, ( 2 )development of a relationship between the ...

**curve**and the crack length , and ( 3) calculation of fatigue life using the conventional S - N approach . where a is the

crack ...

Page 363

50 In order to combine these equivalent S - N

- N equation , i . e . Equation 1 , the slope and the intercept of each equivalent S -

N

50 In order to combine these equivalent S - N

**curves**into a single conventional S- N equation , i . e . Equation 1 , the slope and the intercept of each equivalent S -

N

**curve**of Figure 3 are determined using a linear regression analysis .Page 406

The type of

steels . STRESS - STRAIN TENSILE

Strain hardening rate versus yield to tensile ratio . The engineering mechanical ...

The type of

**curve**shown in Fig . lc is usually obtained for a wide range of ferriticsteels . STRESS - STRAIN TENSILE

**CURVE**OF DEFECT FREE MATERIAL .Strain hardening rate versus yield to tensile ratio . The engineering mechanical ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

ADVANCED COMPOSITES | 1 |

Optimal Design of Filament Wound Composite Pressure Vessels | 25 |

ADVANCES IN WELDING TECHNOLOGY | 31 |

Copyright | |

34 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied areas assessment base bending brittle calculated carbon carried Charpy chord coarse grained compared composition concentration concrete considered cooling corrosion crack tip critical CTOD curve cycles defect depth developed distribution effect element energy Engineering fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry given hardness heat input higher impact increase indicated initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plate position present pressure problem procedure produced programme properties range reduced region Research respectively sampled shown shows simulated specification specimens steel stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone