Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 226
... depth of carbonation in situ , a 3 % solution of phenolphthalein was used . The depth of erosion on the caisson wall has been checked by measuring the distance between straight- edges placed on concrete surfaces above and beneath the ...
... depth of carbonation in situ , a 3 % solution of phenolphthalein was used . The depth of erosion on the caisson wall has been checked by measuring the distance between straight- edges placed on concrete surfaces above and beneath the ...
Page 371
... depth a . This means that the crack shape changes from elliptical to edge crack at approximately the same depth indepen- dent of plate thickness . In Eq.19 the function Y depends both on a and on a . In Fig.10 , where the aspect ratio a ...
... depth a . This means that the crack shape changes from elliptical to edge crack at approximately the same depth indepen- dent of plate thickness . In Eq.19 the function Y depends both on a and on a . In Fig.10 , where the aspect ratio a ...
Page 453
... DEPTH ( mm ) 8 D 040 80 100 103 50 150 200 250 300 STRESS RANGE ( MPa ) Figure 11 : Maximum crack depth ( ag ) when a dominant irregular crack has developed . 0.4 0.3ps O - T8B - 100 MPa - A - T78 150 MPa O - T98 - 200 MPa SINGLE CRACK ...
... DEPTH ( mm ) 8 D 040 80 100 103 50 150 200 250 300 STRESS RANGE ( MPa ) Figure 11 : Maximum crack depth ( ag ) when a dominant irregular crack has developed . 0.4 0.3ps O - T8B - 100 MPa - A - T78 150 MPa O - T98 - 200 MPa SINGLE CRACK ...
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
26 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical chord coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycle defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows simulated specific specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone