Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 128
가 , SCATTERED BEAM INCIDENT BEAM The coordinate system used to define directions in the T - weld is shown in Fig . ... Thus a sizeable fraction of grains have an ( 002 ) direction aligned with x , the normal to the cross - piece of the ...
가 , SCATTERED BEAM INCIDENT BEAM The coordinate system used to define directions in the T - weld is shown in Fig . ... Thus a sizeable fraction of grains have an ( 002 ) direction aligned with x , the normal to the cross - piece of the ...
Page 540
L - and T - denote the loading axis with respect to the rolling direction of duplex stainless steel . Subcritical crack growth velocity in GTA and GMA weld metals compared with that in base metal in transverse direction , 600 D - D400F ...
L - and T - denote the loading axis with respect to the rolling direction of duplex stainless steel . Subcritical crack growth velocity in GTA and GMA weld metals compared with that in base metal in transverse direction , 600 D - D400F ...
Page 571
It can be seen from Figure 13 that the effect of compression in the y - direction is more distinctive than that in the x - direction ... The stresses in the directions of 45 ° to the x- and y - axes are also shown in Figures 12 and 13 .
It can be seen from Figure 13 that the effect of compression in the y - direction is more distinctive than that in the x - direction ... The stresses in the directions of 45 ° to the x- and y - axes are also shown in Figures 12 and 13 .
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |