Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 177
The effect of peak temperature in HAZ simulation ( single cycle ) on Charpy - V energy level at -40 ° C in as - welded and PWHT condition for ( a ) STEEL A ( N " -old " ) , ( b ) STEEL B ( N- " modern " ) and ( c ) STEEL C ( CONRAC ) .
The effect of peak temperature in HAZ simulation ( single cycle ) on Charpy - V energy level at -40 ° C in as - welded and PWHT condition for ( a ) STEEL A ( N " -old " ) , ( b ) STEEL B ( N- " modern " ) and ( c ) STEEL C ( CONRAC ) .
Page 419
The influence of longitudinal or transverse taken specimens on CVN - energy at the same sampling position was much smaller . Charpy - V - Notch - energy in 1 100 Rolling Grection on 50 TLE TLM -150-130 -110 -90-70 -50 -30 .50 - 10 • 10 ...
The influence of longitudinal or transverse taken specimens on CVN - energy at the same sampling position was much smaller . Charpy - V - Notch - energy in 1 100 Rolling Grection on 50 TLE TLM -150-130 -110 -90-70 -50 -30 .50 - 10 • 10 ...
Page 512
Fe E 460 t8 / 5 40 s Fe E 460 transverse surface notch t8 / 5 15 s transverse surface notch : 00 100 width of CGZ in mm 75 75 width of CGZ in mm 1.7 2.1 2.9 1 1.7 2.1 base plate 1 so 50 CVN ABSORBED ENERGY IN JOULES CVN ABSORBED ENERGY ...
Fe E 460 t8 / 5 40 s Fe E 460 transverse surface notch t8 / 5 15 s transverse surface notch : 00 100 width of CGZ in mm 75 75 width of CGZ in mm 1.7 2.1 2.9 1 1.7 2.1 base plate 1 so 50 CVN ABSORBED ENERGY IN JOULES CVN ABSORBED ENERGY ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |