Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 194
In this section selected requirements will be subject to comment regarding their relevance and ease of application . a Straightness of Fusion Boundary a a can This refers to the provision of K or 4K type weldments for through thickness ...
In this section selected requirements will be subject to comment regarding their relevance and ease of application . a Straightness of Fusion Boundary a a can This refers to the provision of K or 4K type weldments for through thickness ...
Page 289
mm to The aim was to position the pre - fatigue cracks in the LBZ specimens at the fusion line and in the weld metal , 0.5 above the fusion line respectively . The idea was simulate a crack in a LBZ , and a crack growing into a LBZ ...
mm to The aim was to position the pre - fatigue cracks in the LBZ specimens at the fusion line and in the weld metal , 0.5 above the fusion line respectively . The idea was simulate a crack in a LBZ , and a crack growing into a LBZ ...
Page 350
The fusion line hardness of EH 345 welded joint has the highest value of 230 Hv and the hardness of base metal has the lowest value of 150 Hv . amplitude , because strain amplitude remains constant .
The fusion line hardness of EH 345 welded joint has the highest value of 230 Hv and the hardness of base metal has the lowest value of 150 Hv . amplitude , because strain amplitude remains constant .
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |