Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 93
Page 100
... heat input welding of 11kJ / mm . The impact values in the welded joints with a heat input of 4.5kJ / mm was higher than 240J . The PWHT exerted little influence on the impact values in the welded joint of YS 460MPa class steel . OCTOD ...
... heat input welding of 11kJ / mm . The impact values in the welded joints with a heat input of 4.5kJ / mm was higher than 240J . The PWHT exerted little influence on the impact values in the welded joint of YS 460MPa class steel . OCTOD ...
Page 123
... heat input · - effect of PWHT - - effect of parent material toughness effect of parent material nitrogen and phosphorus content difference between ingot and concast material Variation in Toughness with Heat Input As welding heat input ...
... heat input · - effect of PWHT - - effect of parent material toughness effect of parent material nitrogen and phosphorus content difference between ingot and concast material Variation in Toughness with Heat Input As welding heat input ...
Page 193
... HEAT INPUT LIMITATION The previous section dealt with a proposal to shift the ma jor responsibility for HAZ properties to the steel purchaser with a consequent reduction in that attributed to the fabricator . However there remains a ...
... HEAT INPUT LIMITATION The previous section dealt with a proposal to shift the ma jor responsibility for HAZ properties to the steel purchaser with a consequent reduction in that attributed to the fabricator . However there remains a ...
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
26 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical chord coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycle defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows simulated specific specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone