## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |

### From inside the book

Results 1-3 of 80

Page 158

To investigate the effect of the chord

ends on the load deflection relationship and the ultimate load , a series of studies

were conducted always using the coarse mesh , changing the

...

To investigate the effect of the chord

**length**and the boundary conditions at itsends on the load deflection relationship and the ultimate load , a series of studies

were conducted always using the coarse mesh , changing the

**length**of the chord...

Page 362

The stress intensity factor for a crack in a finite geometry can be written in the

following general form : K = BKO ( 6 ) where B is called the total correction factor

and is a function of the crack

The stress intensity factor for a crack in a finite geometry can be written in the

following general form : K = BKO ( 6 ) where B is called the total correction factor

and is a function of the crack

**length**and dimensions of structural and crack ...Page 365

103 Stress Range , S , N / MM ? Crack

mm 60 . 0 mm • 100 . 0 mm A 150 . 0 mm o 200 . 0 mm x 300 . 0 mm stress

endurance limit below which the specimen will not fail within a reasonable test

time .

103 Stress Range , S , N / MM ? Crack

**Length**0 10 . 0 mm 0 20 . 0 mm 0 40 . 0mm 60 . 0 mm • 100 . 0 mm A 150 . 0 mm o 200 . 0 mm x 300 . 0 mm stress

endurance limit below which the specimen will not fail within a reasonable test

time .

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

ADVANCED COMPOSITES | 1 |

Optimal Design of Filament Wound Composite Pressure Vessels | 25 |

ADVANCES IN WELDING TECHNOLOGY | 31 |

Copyright | |

34 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied areas assessment base bending brittle calculated carbon carried Charpy chord coarse grained compared composition concentration concrete considered cooling corrosion crack tip critical CTOD curve cycles defect depth developed distribution effect element energy Engineering fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry given hardness heat input higher impact increase indicated initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plate position present pressure problem procedure produced programme properties range reduced region Research respectively sampled shown shows simulated specification specimens steel stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone