Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 90
Page 15
( b ) Maximum Stress Criterion The maximum stress criterion compares the stress in any layer ( be it axial , circumferential or shear ) with the ultimate strength of that layer in the appropriate direction , depending on whether it is in ...
( b ) Maximum Stress Criterion The maximum stress criterion compares the stress in any layer ( be it axial , circumferential or shear ) with the ultimate strength of that layer in the appropriate direction , depending on whether it is in ...
Page 17
F06 06 105 LAYUP 05 TSAI - HILL MAXIMUM MAXIMUM MAXIMUM MAXIMUM AXIAL CIRC . AXIAL CIRC . STRAIN STRAIN STRESS STRESS tCR CR e OVER Maximum F04 Stress Criterion 103 0.158 -0.233 - 1.773 - 0.818 Tsai - Hill Criterion qca 03 0.042 S1 que ...
F06 06 105 LAYUP 05 TSAI - HILL MAXIMUM MAXIMUM MAXIMUM MAXIMUM AXIAL CIRC . AXIAL CIRC . STRAIN STRAIN STRESS STRESS tCR CR e OVER Maximum F04 Stress Criterion 103 0.158 -0.233 - 1.773 - 0.818 Tsai - Hill Criterion qca 03 0.042 S1 que ...
Page 71
MAIN INPUT PARAMETERS Design Check Partial Coefficients The fracture mechanics models outlined in the preceeding section could then be used by the designer for the following situations : maximum utilized stress minimum required fracture ...
MAIN INPUT PARAMETERS Design Check Partial Coefficients The fracture mechanics models outlined in the preceeding section could then be used by the designer for the following situations : maximum utilized stress minimum required fracture ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |