Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 87
Page 196
Where a fabricator proposes weld procedures which have demonstrable record of satisfactory past production performance and supporting test data there is little to justify retesting this procedure merely to satisfy minor changes in the ...
Where a fabricator proposes weld procedures which have demonstrable record of satisfactory past production performance and supporting test data there is little to justify retesting this procedure merely to satisfy minor changes in the ...
Page 254
A revised manufacturing procedure was submitted for review that had five essential - variable changes designed to reduce the surface hardness . One plate had strength at such a low level that the manufacturer expected ...
A revised manufacturing procedure was submitted for review that had five essential - variable changes designed to reduce the surface hardness . One plate had strength at such a low level that the manufacturer expected ...
Page 298
For material or welding procedure selection purposes the CTOD tests are required to determine lower bound CTOD values which may control the fracture behaviour of the welded joints ( 21 ) . The main purpose of the tests is to establish a ...
For material or welding procedure selection purposes the CTOD tests are required to determine lower bound CTOD values which may control the fracture behaviour of the welded joints ( 21 ) . The main purpose of the tests is to establish a ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |