Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 122
Butt welds were produced by steelmakers their sub - contractors with half K preparations on 25mm and K preparations ... carbon equivalent within 0.02 % of the agreed maximum and sulphur content within 0.001 % of the production minimum .
Butt welds were produced by steelmakers their sub - contractors with half K preparations on 25mm and K preparations ... carbon equivalent within 0.02 % of the agreed maximum and sulphur content within 0.001 % of the production minimum .
Page 124
No low toughness tests were conducted on ingot material as the ingot steel produced gave consistently high Charpy results in the parent plate . There is scatter in the CGZ Charpy results for both ingot and concast material .
No low toughness tests were conducted on ingot material as the ingot steel produced gave consistently high Charpy results in the parent plate . There is scatter in the CGZ Charpy results for both ingot and concast material .
Page 209
The conventional normalizing treatment ( Steel A ) produced ferritic - pearlitic microstructure of ASTM grain size 8-9 with a mean hardness of 172 HV0,5 . The quenched and tempered steel B has a ferritic - bainitic microstructure with ...
The conventional normalizing treatment ( Steel A ) produced ferritic - pearlitic microstructure of ASTM grain size 8-9 with a mean hardness of 172 HV0,5 . The quenched and tempered steel B has a ferritic - bainitic microstructure with ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |