Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 2
Also , table 4 shows that pultruded composites are equivalent or superior to hot - pressed ones in mechanical properties . For PPS composites , pultruded rods have the same properties as do unidirectional composites made by compression ...
Also , table 4 shows that pultruded composites are equivalent or superior to hot - pressed ones in mechanical properties . For PPS composites , pultruded rods have the same properties as do unidirectional composites made by compression ...
Page 11
PROPERTY COMPARISON FOR PPS AND PAS - 2 NEAT RESINS PPS Resin Density , g / cc 1.36 Tensile strength , psi 11,400 Elongation , % 2-20 ... These laminates have ambient temperature properties similar to those observed for PPS composites .
PROPERTY COMPARISON FOR PPS AND PAS - 2 NEAT RESINS PPS Resin Density , g / cc 1.36 Tensile strength , psi 11,400 Elongation , % 2-20 ... These laminates have ambient temperature properties similar to those observed for PPS composites .
Page 91
MECHANICAL PROPERTIES OF PLATE When a thick steel plate is rolled , the material near the surface is more ... No significant difference in mechanical properties was observed between quarter thickness and mid - thickness . over an Table ...
MECHANICAL PROPERTIES OF PLATE When a thick steel plate is rolled , the material near the surface is more ... No significant difference in mechanical properties was observed between quarter thickness and mid - thickness . over an Table ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |