Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 193
HEAT INPUT LIMITATION However , any proposed extension to the heat input range ( and indeed the original range proposed ) should be subject not only to tests examining the toughness performance but also the hardenability in terms of ...
HEAT INPUT LIMITATION However , any proposed extension to the heat input range ( and indeed the original range proposed ) should be subject not only to tests examining the toughness performance but also the hardenability in terms of ...
Page 451
Figure 6 is a curve of hot spot stress range ( s ) plotted against total life ( Nt ) . Visual examination of this figure clearly indicates that NT decreases with increase in section thickness but that Nt is generally longer in the ...
Figure 6 is a curve of hot spot stress range ( s ) plotted against total life ( Nt ) . Visual examination of this figure clearly indicates that NT decreases with increase in section thickness but that Nt is generally longer in the ...
Page 471
The experimental results obtained on A , B material and raw material are shown , respectively , in Fig.7 - Fig.9 as log - log relationship between corrosion fatigue crack propagation rate , da / dN , and stress intensity factor range ...
The experimental results obtained on A , B material and raw material are shown , respectively , in Fig.7 - Fig.9 as log - log relationship between corrosion fatigue crack propagation rate , da / dN , and stress intensity factor range ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |