Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 75
Residual stresses effects Onom Weld residual stresses in as welded - structures will set a base reference stress level ... FOR ACCUMULATED STRAIN be present in as welded condition although no external TECHNIQUE ; BILINEAR STRESS STRAIN ...
Residual stresses effects Onom Weld residual stresses in as welded - structures will set a base reference stress level ... FOR ACCUMULATED STRAIN be present in as welded condition although no external TECHNIQUE ; BILINEAR STRESS STRAIN ...
Page 288
For the bend specimens , the yield zone at the crack tip does not extend to the back surface before the nominal stress causes the surface layer also to yield and the two yield zones coincide . This observation gives estimate for the ...
For the bend specimens , the yield zone at the crack tip does not extend to the back surface before the nominal stress causes the surface layer also to yield and the two yield zones coincide . This observation gives estimate for the ...
Page 336
inclusions remain firmly bonded to the matrix , and as far as no pitting corrosion has occurred . stress fatigue cracks . On the other hand , the results for o suggest that cyclic - plastic zones will not develop at the site of holes ...
inclusions remain firmly bonded to the matrix , and as far as no pitting corrosion has occurred . stress fatigue cracks . On the other hand , the results for o suggest that cyclic - plastic zones will not develop at the site of holes ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |