Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 82
Page 93
the effect of peak temperature of the second heat cycle on the Charpy absorbed energy at 0 ° C for a 76 mm thick , 355MPa yield strength steel plate produced by MACS . The peak temperature of the first heat cycle was 1400 ° C which made ...
the effect of peak temperature of the second heat cycle on the Charpy absorbed energy at 0 ° C for a 76 mm thick , 355MPa yield strength steel plate produced by MACS . The peak temperature of the first heat cycle was 1400 ° C which made ...
Page 177
50 59 50 8 8 600 600 800 1800 1200 1400 Temperature ( degr . C ) 600 800 1000 1288 1480 Temperature ( degr . ... The effect of peak temperature in HAZ simulation ( single cycle ) on Charpy - V energy level at -40 ° C in as - welded and ...
50 59 50 8 8 600 600 800 1800 1200 1400 Temperature ( degr . C ) 600 800 1000 1288 1480 Temperature ( degr . ... The effect of peak temperature in HAZ simulation ( single cycle ) on Charpy - V energy level at -40 ° C in as - welded and ...
Page 592
Phase 3 c ) Evaluation of assembled crane components to Phase 1 philosophy for a design temperature of -10 ° C and test lift performance . d ) Structural design has sufficient redundancy to withstand a failure in this area .
Phase 3 c ) Evaluation of assembled crane components to Phase 1 philosophy for a design temperature of -10 ° C and test lift performance . d ) Structural design has sufficient redundancy to withstand a failure in this area .
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |