Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 78
Page 210
The test conditions for the notched tensile specimens were the same as for the unnotched specimens . Tensile specimens . The dimensions of the tensile specimens are shown in Fig . 3. The specimen diameter at mid-length was reduced to 6 ...
The test conditions for the notched tensile specimens were the same as for the unnotched specimens . Tensile specimens . The dimensions of the tensile specimens are shown in Fig . 3. The specimen diameter at mid-length was reduced to 6 ...
Page 408
3b ) . an INTERACTION BETWEEN THE MATERIAL'S STRESS - STRAIN CHARACTERISTICS AND THE CRACK TIP OPENING . of Because the relation between the yield point elongation , en , the strain hardening rate ( or yield to tensile ratio , R ) and ...
3b ) . an INTERACTION BETWEEN THE MATERIAL'S STRESS - STRAIN CHARACTERISTICS AND THE CRACK TIP OPENING . of Because the relation between the yield point elongation , en , the strain hardening rate ( or yield to tensile ratio , R ) and ...
Page 499
100 Exp . S5 -2 , L5-1.25 -2 ( C : 2.5 Ni ) 07 q Fracture Bending Tensile Mide plate COD Lest tensie lesų pattern test = 100m = 100 ) с o D one OO U 0 A Cumulative frequency ( % ) 50 M figure , bending critical CTOD is also given .
100 Exp . S5 -2 , L5-1.25 -2 ( C : 2.5 Ni ) 07 q Fracture Bending Tensile Mide plate COD Lest tensie lesų pattern test = 100m = 100 ) с o D one OO U 0 A Cumulative frequency ( % ) 50 M figure , bending critical CTOD is also given .
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |