Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 80
Page 210
... Tensile specimens . The dimensions of the tensile speci- mens are shown in Fig . 3. The specimen diameter at mid- -length was reduced to 6,4 mm over a length of 10 mm to aid in obtaining fracture in the center of the simulat- ed portion ...
... Tensile specimens . The dimensions of the tensile speci- mens are shown in Fig . 3. The specimen diameter at mid- -length was reduced to 6,4 mm over a length of 10 mm to aid in obtaining fracture in the center of the simulat- ed portion ...
Page 408
... tensile ratio , the orientation of the yielded zones will effectively approach the direction of 45 ° to the tensile axis , whereas a low strain hardening rate or a high yield to tensile ratio will produce plastic zones which have an ...
... tensile ratio , the orientation of the yielded zones will effectively approach the direction of 45 ° to the tensile axis , whereas a low strain hardening rate or a high yield to tensile ratio will produce plastic zones which have an ...
Page 499
... tensile specimen is an important measure with reference to correlation between bending and tensile critical CTODS . 13 ) Experimental considerations have been conducted on the relationship between bending critical CTODS and critical ...
... tensile specimen is an important measure with reference to correlation between bending and tensile critical CTODS . 13 ) Experimental considerations have been conducted on the relationship between bending critical CTODS and critical ...
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
26 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical chord coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycle defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows simulated specific specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone