Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 85
Page 100
... values satisfied the target value of 40J even in the high heat input welding of 11kJ / mm . The impact values in the welded joints with a heat input of 4.5kJ / mm was higher than 240J . The PWHT exerted little influence on the impact values ...
... values satisfied the target value of 40J even in the high heat input welding of 11kJ / mm . The impact values in the welded joints with a heat input of 4.5kJ / mm was higher than 240J . The PWHT exerted little influence on the impact values ...
Page 371
... value of i than thinner ones if f is kept constant , and the life Nf of the thick components increases . This gives a smaller thickness effect , as shown in Fig . 8. The change in n from the value given by Eq.20 depends on the actual values ...
... value of i than thinner ones if f is kept constant , and the life Nf of the thick components increases . This gives a smaller thickness effect , as shown in Fig . 8. The change in n from the value given by Eq.20 depends on the actual values ...
Page 420
... values could be observed . The shifted values obtained from real weldment specimens are caused by a supporting effect of adjacent regions in the weldment which is lost in simulated specimens / 3 / . RESULTS OF FRACTURE MECHANICS ...
... values could be observed . The shifted values obtained from real weldment specimens are caused by a supporting effect of adjacent regions in the weldment which is lost in simulated specimens / 3 / . RESULTS OF FRACTURE MECHANICS ...
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
26 other sections not shown
Other editions - View all
Common terms and phrases
abrasion analysis as-welded assessment austenite axial base metal behaviour bending boron brittle fracture brittle zones CGHAZ Charpy chemical composition chord coarse grained HAZ concrete Conference on Offshore crack growth crack length CTOD tests CTOD values curve cycle defect effect fabrication ferrite fiber Figure fracture initiation fracture mechanics fracture toughness fusion line grain coarsened HAZ HAZ toughness heat affected zone heat input hydrogen ICCGHAZ impact increase layup load low carbon low toughness martensite material maximum Mechanics and Arctic method niobium Offshore Mechanics offshore structures Oseberg parameters plastic plate thickness pop-in post weld heat preheat PWHT region residual stresses sampled simulated solidification cracking steel plates stiffeners stress concentration stress intensity factor submerged arc welding surface notched Table temperature tensile thermal TMCP transverse tubular joints weld metal weld toe weldability welded joints welding procedures weldments wide plate tests yield strength