Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 85
Page 100
These values satisfied the severest requirement of less than HV 300. The results indicate that short bead welding can be used for ... The impact values satisfied the target value of 40J even in the high heat input welding of 11kJ / mm .
These values satisfied the severest requirement of less than HV 300. The results indicate that short bead welding can be used for ... The impact values satisfied the target value of 40J even in the high heat input welding of 11kJ / mm .
Page 371
Thick components will have a lower value of i than thinner ones if f is kept constant , and the life Nf of the thick components increases . ... The change in n from the value given by Eq . 20 depends on the actual values of Ky and aį .
Thick components will have a lower value of i than thinner ones if f is kept constant , and the life Nf of the thick components increases . ... The change in n from the value given by Eq . 20 depends on the actual values of Ky and aį .
Page 420
are was The CVN - values for the single- and the double - cycle - weld - simulation significantly below those of all other materials . The transition temperature 1273 + 17 ° C and -33 ° c , T50 % was C + 37 ° C and + 12 ° C . No ...
are was The CVN - values for the single- and the double - cycle - weld - simulation significantly below those of all other materials . The transition temperature 1273 + 17 ° C and -33 ° c , T50 % was C + 37 ° C and + 12 ° C . No ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
ADVANCED COMPOSITES | 1 |
A Study of the MultiLayered GRP Composite Cylindrical Vessel | 13 |
Resistance of Composite Structures to Impact Loads | 19 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied areas assessment base bending brittle calculated carbon carried Charpy chemical coarse grained compared composite concrete considered cooling crack tip critical CTOD curve cycles defect depth determined developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture mechanics fracture toughness fusion geometry growth hardness heat input higher impact increase initiation length load lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore offshore structures parameters performed plastic plate position present pressure problem procedure production properties range reduced region Research respectively sampled shown shows significant simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thickness tubular values weld metal welded joints weldments wide yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3 |
| Contributor | American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division |
| Publisher | American Society of Mechanical Engineers, 1988 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |