Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 14, Part 3American Society of Mechanical Engineers, 1995 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 223
EARLY FATIGUE CRACK SHAPE DEVELOPMENT IN WELDED TUBULAR JOINTS Craig C. Monahan Centre for Cold Ocean Resources Engineering Memorial University of Newfoundland St. John's , Canada William D. Dover NDE Centre Department of Mechanical ...
EARLY FATIGUE CRACK SHAPE DEVELOPMENT IN WELDED TUBULAR JOINTS Craig C. Monahan Centre for Cold Ocean Resources Engineering Memorial University of Newfoundland St. John's , Canada William D. Dover NDE Centre Department of Mechanical ...
Page 371
FLAME STRAIGHTENING SHAPE CONTROL OF TMCP STEELS Frank E. Hanus Dillinger Hütte Dillingen Germany HEAT - AFFECTED - ZONE TOUGHNESS OF A ... flame straightening has widely been used for decades to bring the structure to the right shape .
FLAME STRAIGHTENING SHAPE CONTROL OF TMCP STEELS Frank E. Hanus Dillinger Hütte Dillingen Germany HEAT - AFFECTED - ZONE TOUGHNESS OF A ... flame straightening has widely been used for decades to bring the structure to the right shape .
Page 517
It is well known that the shape of a weld pool can influence the microstructure and segregation pattern of the final solidified weld metal . Mechanical properties and susceptibility to defects are consequently affected by the ...
It is well known that the shape of a weld pool can influence the microstructure and segregation pattern of the final solidified weld metal . Mechanical properties and susceptibility to defects are consequently affected by the ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
FATIGUE GUIDANCE FOR OFFSHORE STRUCTURES | 16 |
VOLUME IA OFFSHORE TECHNOLOGY VOLUME II MATERIALS ENGINEERING | 18 |
VOLUME 1B OFFSHORE TECHNOLOGY VOLUME IV ARCTICPOLAR TECHNOLOGY | 135 |
Copyright | |
15 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied approach assessment behaviour bending brace calculated carried chord compared comparison concentration connections crack growth crack tip CTOD curve cycles defect depth determined developed distribution effect Engineering equations estimated evaluation experimental factor failure fatigue crack Figure finite element fracture geometry given guidance heating higher improved included increase influence initiation International length limit load lower material mean measured Mechanics method microstructure mode notch obtained Offshore parameters performed pipe plastic plate position predictions present procedure properties range ratio reduced region repair Report Research residual stress shape shown shows side specimens steel strain strength stress intensity factor structures surface Table temperature tensile thickness toughness tubular joints values weld metal weld toe welded joints wide yield yield strength
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 14, Part 3 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1995 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791813096, 9780791813096 |
| Export Citation | BiBTeX EndNote RefMan |