Uniform Building Code, Volume 1Pacific Coast Building Officials Conference, 1952 - Building laws |
From inside the book
Results 1-3 of 77
Page 81
... metal with all joints in such sheet metal lock- lapped . ( See Chapter 30. ) All openings into any such ver- tical enclosure shall be protected by metal or metal - clad doors with either metal or metal - clad jambs , casings or frames ...
... metal with all joints in such sheet metal lock- lapped . ( See Chapter 30. ) All openings into any such ver- tical enclosure shall be protected by metal or metal - clad doors with either metal or metal - clad jambs , casings or frames ...
Page 150
... metal core shall not exceed 20 per cent of the gross area of the column . If a hollow metal core is used it shall be filled with concrete . The amounts of longitudinal and spiral reinforcement and the requirements as to spacing of bars ...
... metal core shall not exceed 20 per cent of the gross area of the column . If a hollow metal core is used it shall be filled with concrete . The amounts of longitudinal and spiral reinforcement and the requirements as to spacing of bars ...
Page 258
... metal or wire lath is carried around such intersections . Cornerite shall be fastened only sufficiently to retain position during plastering and shall not be rigidly attached to the wood framing . No interior lath shall be applied until ...
... metal or wire lath is carried around such intersections . Cornerite shall be fastened only sufficiently to retain position during plastering and shall not be rigidly attached to the wood framing . No interior lath shall be applied until ...
Contents
Part IAdministrative | 19 |
CHAPTER 3 | 25 |
Part IIIRequirements Based on Occupancy | 33 |
Copyright | |
44 other sections not shown
Other editions - View all
Common terms and phrases
appliance approved asbestos bars beams bolt brick Building Official building or structure ceiling cement cent Chimneys clearance Code column combustible compression compression members compressive strength conform Cont'd designed diameter Douglas fir dry standpipes enclosures exceed exit exterior walls fire doors Fire Zone flammable liquids floor flue or vent foot four inches furnaces girders Grade grain Group grout gypsum heaters height horizontal incombustible materials installed interior joints joists lath least live load located lumber masonry metal minimum mortar occupant load one-half inch one-hour fire-resistive construction partitions permitted pipe plaster portland cement pounds per square proscenium protected reinforced concrete resistance rivets roof shear six inches slab smoke pipe solid space specified in Chapter specified in Section square feet square inch Stairs stairway standpipes steel structural steel studs Subsection Table thickness twenty feet 20 TYPES OF CONSTRUCTION U.B.C. Standard ventilation width wire wood