Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 8, Part 3American Society of Mechanical Engineers, 1989 - Arctic regions |
From inside the book
Results 1-3 of 59
Page 173
... samples makes this treatment very promising . INTRODUCTION Titanium and its alloys are established as very reliable ... samples were heat treated at 900 ° C for 1,2 and 4 hours , furnace cooled to 650 ° C and then air cooled . Two other ...
... samples makes this treatment very promising . INTRODUCTION Titanium and its alloys are established as very reliable ... samples were heat treated at 900 ° C for 1,2 and 4 hours , furnace cooled to 650 ° C and then air cooled . Two other ...
Page 223
... samples performed using from samples furnace followed by were specimens machined laboratory ISO - V test aged in the water quenching . Pitting corrosion behaviour was evaluated in 10 % -ferric chloride solution according to ASTM G 48-76 ...
... samples performed using from samples furnace followed by were specimens machined laboratory ISO - V test aged in the water quenching . Pitting corrosion behaviour was evaluated in 10 % -ferric chloride solution according to ASTM G 48-76 ...
Page 345
... samples was always above 35 % , Fig . 1 . Thoughness and structure of the base metal - Charpy - V - notch specimens from both ends of the plate were tested down to 100 ° C , Fig . 2. Samples were taken transverse to rolling direction in ...
... samples was always above 35 % , Fig . 1 . Thoughness and structure of the base metal - Charpy - V - notch specimens from both ends of the plate were tested down to 100 ° C , Fig . 2. Samples were taken transverse to rolling direction in ...
Contents
THICKNESS EFFECTS | 1 |
MATERIALS TECHNOLOGY | 9 |
The Plate Thickness Effect in Fatigue Predictions and Results A Review of Norwegian Work | 21 |
Copyright | |
56 other sections not shown
Other editions - View all
Common terms and phrases
alloy aluminum analysis applied Arctic Engineering ASTM austenite axial base metal behaviour bending brace calculated cathodic protection Charpy chord Conference on Offshore corrosion fatigue crack depth crack growth rate crack initiation crack propagation crevice corrosion CTOD da/dN defects developed equation experimental fabrication fatigue crack growth fatigue strength fatigue test ferrite Figure fillet welds finite element fracture mechanics fracture toughness geometry grade heat input heat treatment HSLA steels increase influence kJ/cm load material mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics Offshore Structures parameters pipe pitting plate thickness predicted procedure PWHT ratio reduced reheated S-N curves seawater Shoralsim shown in Fig solution specimens Steel in Marine strain stress concentration stress intensity factor stress range submerged arc welding surface crack T-joints Table temperature tensile thickness effect tubular joints values weld metal weld profile weld toe weldability welded joints yield strength