Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 8, Part 3American Society of Mechanical Engineers, 1989 - Arctic regions |
From inside the book
Results 1-3 of 68
Page 347
... values for the MMA weld- ment , Fig . 4. This is due to considerable scattering that may occur with all - weld ... values . On specimens from weld metal only small scatter of the individual values occurred . No differences were found ...
... values for the MMA weld- ment , Fig . 4. This is due to considerable scattering that may occur with all - weld ... values . On specimens from weld metal only small scatter of the individual values occurred . No differences were found ...
Page 521
... values calculated for CA loading are lower than the rms KTH values for VA loading . This is a conservative situation . The major reasons for the observation of larger values under VA loading are : - ( a ) Load interaction effects and ...
... values calculated for CA loading are lower than the rms KTH values for VA loading . This is a conservative situation . The major reasons for the observation of larger values under VA loading are : - ( a ) Load interaction effects and ...
Page 696
... values of the flat specimen decline for the large value of Rm . As was shown earlier , the influence of the stress concentration of the T - joint diminishes in the case of the deep surface crack . It is also seen in Fig . 10 that the ...
... values of the flat specimen decline for the large value of Rm . As was shown earlier , the influence of the stress concentration of the T - joint diminishes in the case of the deep surface crack . It is also seen in Fig . 10 that the ...
Contents
MATERIALS TECHNOLOGY | 9 |
The Plate Thickness Effect in Fatigue Predictions and Results A Review of Norwegian Work | 21 |
Thickness Weld Profile and Initial Flaw Considerations for Tubular Joints | 39 |
Copyright | |
56 other sections not shown
Other editions - View all
Common terms and phrases
adhesion strength alloy aluminum analysis applied Arctic Engineering austenite axial base metal behaviour bending brace calculated cathodic protection Charpy chord composite Conference on Offshore corrosion fatigue crack depth crack front crack growth rate crack initiation crack propagation crevice corrosion CTOD defects developed energy equation experimental fabrication fatigue crack growth fatigue strength ferrite Figure finite element fracture mechanics fracture toughness geometry grade heat input heat treatment HSLA steels increase influence kJ/cm levels line spring load material mechanical properties Mechanics and Arctic method microstructure notch Offshore Mechanics offshore structures parameter pipe pitting pitting corrosion plate thickness predicted PWHT ratio reduced S-N curves shown in Fig solution specimens strain stress concentration stress intensity factor stress range submerged arc welding surface crack T-joints Table temperature tensile thickness effect tubular joints values wall thickness weld metal weld profile weld toe weldability welded joints yield strength