Uniform Building Code, Volume 1International Conference of Building Officials, 1997 - Building laws |
From inside the book
Results 1-3 of 29
Page 1-141
... VENEER 1403.1 Scope . 1403.1.1 General . All veneer and its application shall conform to the requirements of this code . Wainscots not exceeding 4 feet ( 1219 mm ) in height measured above the adjacent ground eleva- tion for exterior veneer ...
... VENEER 1403.1 Scope . 1403.1.1 General . All veneer and its application shall conform to the requirements of this code . Wainscots not exceeding 4 feet ( 1219 mm ) in height measured above the adjacent ground eleva- tion for exterior veneer ...
Page 1-142
... veneer shall comply with the requirements of Chapter 16 and this section . Veneer shall support no load other than its own weight and the vertical dead load of veneer above . Surfaces to which veneer is attached shall be designed to sup ...
... veneer shall comply with the requirements of Chapter 16 and this section . Veneer shall support no load other than its own weight and the vertical dead load of veneer above . Surfaces to which veneer is attached shall be designed to sup ...
Page 1-143
... veneer in which case spot bedding at all ties shall be of cement mortar . 2. Veneer may be applied with 1 - inch - minimum ( 25 mm ) grouted backing space reinforced by not less than 2 - inch- by - 2 - inch ( 51 mm by 51 mm ) 0.065 ...
... veneer in which case spot bedding at all ties shall be of cement mortar . 2. Veneer may be applied with 1 - inch - minimum ( 25 mm ) grouted backing space reinforced by not less than 2 - inch- by - 2 - inch ( 51 mm by 51 mm ) 0.065 ...
Contents
UBC Standard 21 Noncombustible MaterialTests | 1-7 |
UBC Standard 72 Fire Tests of Door Assemblies | 1-68 |
UBC Standard 2111 | 1-94 |
Copyright | |
8 other sections not shown
Other editions - View all
Common terms and phrases
accessible aggregate aisle applied approved area of refuge ASTM automatic sprinkler system B.W. gage braced wall lines building official building or structure ceiling cement combustible comply concrete conform corridor Division 3 Occupancies doors dwelling units elevator equipment exceed EXCEPTION exit-access exterior walls fire assembly Fire Code fire-resistive construction fire-resistive rating floor area grade Group H grout gypsum hazardous height inches inspection installed insulation joists kN/m² live load located masonry materials maximum means of egress minimum N/C less nails noncombustible occupancy separation occupant load one-hour fire-resistive openings panels percent perlite portion reinforcement requirements of Section roof rooms Select Structural sheathing slope smoke smoke detector space specified in Chapter specified in Section square feet stairways standpipes steel storage story studs surface Table tested thickness tion Type UBC Standard Uniform Building Code units vertical veneer ventilation vermiculite vertical in 12 wallboard water closet width wire wood