Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 16, Parts 2-3American Society of Mechanical Engineers, 1997 - Arctic regions |
From inside the book
Results 1-3 of 86
Page 284
... table with water tank . The specifications of the underwater shaking table used for the tests are listed in Table 1. The shape of shaking table is 5.65m diameter circle and which is installed at the bottom of 15m square , 2m depth water ...
... table with water tank . The specifications of the underwater shaking table used for the tests are listed in Table 1. The shape of shaking table is 5.65m diameter circle and which is installed at the bottom of 15m square , 2m depth water ...
Page 311
... ( Table 3 ) . For SC - C , y = 1.4 . The seismotectonic geology of this region is characterized with shallow strike - slip and thrust faulting ; thus , & = 1.0 ( Table 3 ) . The spectra ordinates for periods greater than T = 1 second are ...
... ( Table 3 ) . For SC - C , y = 1.4 . The seismotectonic geology of this region is characterized with shallow strike - slip and thrust faulting ; thus , & = 1.0 ( Table 3 ) . The spectra ordinates for periods greater than T = 1 second are ...
Page 102
Table 1 Chemical compositions and tensile properties of materials used Mark * C Si Mn P S Ni Cr Mo Ti N Y.S T.S No.1 0.007 0.31 0.45 0.018 0.001 6.20 12.05 2.53 0.070 ... Table 3 Welding conditions applied Table 4 Conditions for constant 102.
Table 1 Chemical compositions and tensile properties of materials used Mark * C Si Mn P S Ni Cr Mo Ti N Y.S T.S No.1 0.007 0.31 0.45 0.018 0.001 6.20 12.05 2.53 0.070 ... Table 3 Welding conditions applied Table 4 Conditions for constant 102.
Contents
SPECTRAL MODELLING OF WAVES | 1 |
RISK ANALYSIS | 33 |
PROBABILISTIC MODELLING OF WAVES | 99 |
Copyright | |
6 other sections not shown
Other editions - View all
Common terms and phrases
alloys aluminium analysis applied ASME assessment base metal bending brittle fracture calculated coefficient corrosion fatigue crack arrestability crack depth crack growth crack tip CTOD curve damage defects deformation dent Det Norske Veritas developed distribution dynamic earthquake effect energy Engineering equation estimated evaluated factor failure fatigue crack Figure fracture mechanics fracture toughness frequency function heat increase initiation inspection Japan maintenance martensitic material maximum mbar measured mechanical properties method notch observed obtained offshore structures OMAE parameters peening performed pipe plastic platform prediction pressure procedure ratio reliability response risers S-N curve safety sea water seismic shielding gas ship shown in Fig simulation single-sided welds specimens spectra spectrum statistical steel plate strain stress range surface Table temperature tensile toughness tubular underwater underwater welding vertical wave height Weibull distribution weld metal welded joints width yield strength yield stress