Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 16, Parts 2-3American Society of Mechanical Engineers, 1997 - Arctic regions |
From inside the book
Results 1-3 of 47
Page 259
... limited ductile crack growth ( 0.8 and 2.1 mm ) . The third specimen had crack tip about 1 mm from fusion line . This specimen showed also limited crack growth ( 2.2 ) but the deformation at the crack tip was higher and the crack growth ...
... limited ductile crack growth ( 0.8 and 2.1 mm ) . The third specimen had crack tip about 1 mm from fusion line . This specimen showed also limited crack growth ( 2.2 ) but the deformation at the crack tip was higher and the crack growth ...
Page 314
... limited due to restricted access . It was concluded [ 6 ] that those regions left unwelded for visual inspection of the root run are very susceptible to defects on subsequent welding . In general , those flaws rejected by CVI were also ...
... limited due to restricted access . It was concluded [ 6 ] that those regions left unwelded for visual inspection of the root run are very susceptible to defects on subsequent welding . In general , those flaws rejected by CVI were also ...
Page 342
... limited range of diameters , the resulting member slendernesses fall in the range 0.34 to 0.58 which might apply to a limited number of leg and brace members . The procedure contained within the proposed ISO requirements , whilst ...
... limited range of diameters , the resulting member slendernesses fall in the range 0.34 to 0.58 which might apply to a limited number of leg and brace members . The procedure contained within the proposed ISO requirements , whilst ...
Contents
SPECTRAL MODELLING OF WAVES | 1 |
RISK ANALYSIS | 33 |
PROBABILISTIC MODELLING OF WAVES | 99 |
Copyright | |
6 other sections not shown
Other editions - View all
Common terms and phrases
alloys aluminium analysis applied ASME assessment base metal bending brittle fracture calculated coefficient corrosion fatigue crack arrestability crack depth crack growth crack tip CTOD curve damage defects deformation dent Det Norske Veritas developed distribution dynamic earthquake effect energy Engineering equation estimated evaluated factor failure fatigue crack Figure fracture mechanics fracture toughness frequency function heat increase initiation inspection Japan maintenance martensitic material maximum mbar measured mechanical properties method notch observed obtained offshore structures OMAE parameters peening performed pipe plastic platform prediction pressure procedure ratio reliability response risers S-N curve safety sea water seismic shielding gas ship shown in Fig simulation single-sided welds specimens spectra spectrum statistical steel plate strain stress range surface Table temperature tensile toughness tubular underwater underwater welding vertical wave height Weibull distribution weld metal welded joints width yield strength yield stress