## Mechanical metallurgy |

### From inside the book

Results 1-3 of 55

Page 334

strain curve is the

elasticity is a measure of the stiffness of the material. The greater the

the ...

**MODULUS**OF ELASTICITY The slope of the initial linear portion of the stress-strain curve is the

**modulus**of elasticity, or Young's**modulus**. The**modulus**ofelasticity is a measure of the stiffness of the material. The greater the

**modulus**,the ...

Page 335

Table 9-1 TYPICAL VALUES OF MODULES OF ELASTICITY AT DIFFERENT

TEMPERATURES

material to absorb energy when deformed elastically and to return it when

unloaded ...

Table 9-1 TYPICAL VALUES OF MODULES OF ELASTICITY AT DIFFERENT

TEMPERATURES

**Modulus**of elasticity, psi x 10- 6 RESILIENCE The ability of amaterial to absorb energy when deformed elastically and to return it when

unloaded ...

Page 381

Experience has shown that for determinations of the shearing yield strength and

outside diameter should be about 10 and the diameter-thickness ratio should be

...

Experience has shown that for determinations of the shearing yield strength and

**modulus**of elasticity the ratio of the length of the reduced test section to theoutside diameter should be about 10 and the diameter-thickness ratio should be

...

### What people are saying - Write a review

User Review - Flag as inappropriate

Actually, this book is one of the most important books for a metallurgist and materials scientist, and is necessary to be studied!!

User Review - Flag as inappropriate

One of the best books for Metallurgy. You will always need this book throughout your life (considering you are a Metallurgist).

### Contents

Introduction | 3 |

Elements of the Theory of Plasticity | 72 |

Plastic Deformation of Single Crystals | 105 |

Copyright | |

19 other sections not shown

### Other editions - View all

### Common terms and phrases

alloys angle annealed atoms axes axis behavior billet brittle fracture Burgers vector cold-worked components compression constant crack criterion cross slip cycles decrease determined diameter direction dislocation line ductile edge dislocation elastic elongation energy engineering equations extrusion factor failure fatigue limit fibers flow curve flow stress force forging friction given grain boundaries hot-working hydrostatic increases lattice length load machining martensite material matrix maximum measured mechanical metallurgical Metals Park modulus normal stress notch occurs orientation particles percent plastic deformation plastic strain polymer pressure produced properties ratio reduction region residual stresses rolling screw dislocation shear strain shear stress sheet shown in Fig shows slip plane slip systems Society for Metals solid specimen steel strain hardening strain rate stress-strain curve structure surface tensile strength tensile stress tensor theory thermal thickness tool torsion Trans usually velocity workpiece yield strength yield stress York