Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 4American Society of Mechanical Engineers, 1999 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 76
... applied internal pressure on the end plates of the test set - up and the axial loads due to the effects of Poisson's ratio ( v ) were considered when determining the target value of the external load to be applied during testing . 2.4 ...
... applied internal pressure on the end plates of the test set - up and the axial loads due to the effects of Poisson's ratio ( v ) were considered when determining the target value of the external load to be applied during testing . 2.4 ...
Page 77
... applying an end moment and curvature to the specimens . Jack force increments were in the order of 100 kN per load step , resulting in a stepwise- applied end moment of approximately 150 kN - m . 7. With each increase in jack force ...
... applying an end moment and curvature to the specimens . Jack force increments were in the order of 100 kN per load step , resulting in a stepwise- applied end moment of approximately 150 kN - m . 7. With each increase in jack force ...
Page 172
... applied to the branch end to simulate the axial force due to the applied internal pressure . Similarly , nodes at the end of the run pipe opposite the symmetry plane were constrained to remain planar and a negative pressure was applied ...
... applied to the branch end to simulate the axial force due to the applied internal pressure . Similarly , nodes at the end of the run pipe opposite the symmetry plane were constrained to remain planar and a negative pressure was applied ...
Contents
PIPELINE RELIABILITY AND LIMIT STATES DESIGN | 1 |
DESIGN OF PIPELINES AND RISERS | 5 |
OMAE99PIPE5019 | 21 |
Copyright | |
30 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied Arctic Engineering ASME assessment autoclave axial force bending buckling calculated capacity Conference On Offshore Copyright corrosion corrosion defect crack defined deformation dent depth Det Norske Veritas developed diameter discrete displacement vector effect equation failure modes failure probability Figure finite element finite element analysis fracture friction function fuzzy logic gasket geotechnical engineering GTAW hoop stress hot tap tee InSAR installation internal pressure jumper length Limit State Design load longitudinal MANAVGAT material maximum measured Mechanics and Arctic modal displacement neural networks node Offshore Mechanics operating pressure ovalisation parameters Petrobras pipe material pipe wall pipeline design Pipeline Systems plastic reliability riser risk run pipe saddle safety class seabed simulation SMAW SMYS specimens stinger strain stress Table Technology temperature tensile test scheme uprating valve wall thickness yield strength ας მთ მი მს