Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 4American Society of Mechanical Engineers, 1999 - Arctic regions |
From inside the book
Results 1-3 of 20
Page 157
ALLOWABLE HEAT INPUT AND MECHANICAL PROPERTIES OF REPAIR WELD BY DIRECT DEPOSITION OF WELD METAL Woo - sik Kim R & D Center , Korea Gas Corporation , Table 1. The chemical compositions ( wt % ) of.
ALLOWABLE HEAT INPUT AND MECHANICAL PROPERTIES OF REPAIR WELD BY DIRECT DEPOSITION OF WELD METAL Woo - sik Kim R & D Center , Korea Gas Corporation , Table 1. The chemical compositions ( wt % ) of.
Page 159
The proportional constant ( A ) of linear regression through origin and calculated allowable heat input on the basis of the depth of HAZ . Plate SMAW GTAW thickness Proportional constant ( A ) Allowable heat input ( kJ / cm ) ...
The proportional constant ( A ) of linear regression through origin and calculated allowable heat input on the basis of the depth of HAZ . Plate SMAW GTAW thickness Proportional constant ( A ) Allowable heat input ( kJ / cm ) ...
Page 274
TEMPERATURE REGULATION A heat exchanger is installed to regulate the temperature of the oil in the autoclave The autoclave has two outlets . One is used during pressure reduction while the other leads to a ...
TEMPERATURE REGULATION A heat exchanger is installed to regulate the temperature of the oil in the autoclave The autoclave has two outlets . One is used during pressure reduction while the other leads to a ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
PIPELINE RELIABILITY AND LIMIT STATES DESIGN | 1 |
DESIGN OF PIPELINES AND RISERS | 5 |
OMAE99PIPE5019 | 21 |
Copyright | |
22 other sections not shown
Other editions - View all
Common terms and phrases
acceptable allowable analysis applied approach ASME assessment associated assumed axial bending branch buckling calculated capacity Conference considered construction Copyright corrosion cost crack defect defined deformation dent depth described determine developed diameter direction displacement distribution effect element Engineering equation factor failure field Figure force fracture function fuzzy given heat increase initial input inspection installation internal internal pressure joint length limit load material maximum measured Mechanics method modes neural networks obtained occur Offshore operating parameters performed pipe pipeline plastic possible predicted presented pressure probability problem range reduce reliability represent respectively risk safety sand shown shows soil specified specimens standard steel strain strength stress structural surface Table Technology temperature valve wall thickness weld yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 4 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1999 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |