Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 4American Society of Mechanical Engineers, 1999 - Arctic regions |
From inside the book
Results 1-3 of 58
Page 126
... performed by a backhoe up to the 3 - m water depth . The remaining of the trench was performed by a clamshell barge ( Fig.11 ) and a cutter suction dredger up to 20 - m water depth . The pipelines were pulled into the open trenches by a ...
... performed by a backhoe up to the 3 - m water depth . The remaining of the trench was performed by a clamshell barge ( Fig.11 ) and a cutter suction dredger up to 20 - m water depth . The pipelines were pulled into the open trenches by a ...
Page 186
... performed for the two extreme cases of ( i ) no axial constraint and ( ii ) full axial constraint . All welds will experience fatigue damage of less than 10 % over the design life under conditions of no axial constraint or under full ...
... performed for the two extreme cases of ( i ) no axial constraint and ( ii ) full axial constraint . All welds will experience fatigue damage of less than 10 % over the design life under conditions of no axial constraint or under full ...
Page 282
... performed selecting an element length equal to 2.5 to 5.0 m for the end - sections and the TDP zone , increasing to 10.0 to 30.0 m in the central zones . For the rest condition , static analysis was performed , while near and far ...
... performed selecting an element length equal to 2.5 to 5.0 m for the end - sections and the TDP zone , increasing to 10.0 to 30.0 m in the central zones . For the rest condition , static analysis was performed , while near and far ...
Contents
PIPELINE RELIABILITY AND LIMIT STATES DESIGN | 1 |
DESIGN OF PIPELINES AND RISERS | 5 |
OMAE99PIPE5019 | 21 |
Copyright | |
30 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied Arctic Engineering ASME assessment autoclave axial force bending buckling calculated capacity Conference On Offshore Copyright corrosion corrosion defect crack defined deformation dent depth Det Norske Veritas developed diameter discrete displacement vector effect equation failure modes failure probability Figure finite element finite element analysis fracture friction function fuzzy logic gasket geotechnical engineering GTAW hoop stress hot tap tee InSAR installation internal pressure jumper length Limit State Design load longitudinal MANAVGAT material maximum measured Mechanics and Arctic modal displacement neural networks node Offshore Mechanics operating pressure ovalisation parameters Petrobras pipe material pipe wall pipeline design Pipeline Systems plastic reliability riser risk run pipe saddle safety class seabed simulation SMAW SMYS specimens stinger strain stress Table Technology temperature tensile test scheme uprating valve wall thickness yield strength ας მთ მი მს