Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 4American Society of Mechanical Engineers, 1999 - Arctic regions |
From inside the book
Results 1-3 of 40
Page 54
... specified by a standard deviation of 4 % of the thickness and material quality where the supplementary requirements “ U ” are specified . As can be seen the annual failure probability for the different design cases is again relative ...
... specified by a standard deviation of 4 % of the thickness and material quality where the supplementary requirements “ U ” are specified . As can be seen the annual failure probability for the different design cases is again relative ...
Page 55
... specified 1.0E - 03 1.0E - 04 1.0E - 05 1.0E - 06 Target P 1.0E + 00 1.0E - 01 Annual failure probability 1.0E - 02 Calibration results ; LRFD Safety class : Low Inspection : relative measure Inspection accuracy : StD ( d / t ) = 16 ...
... specified 1.0E - 03 1.0E - 04 1.0E - 05 1.0E - 06 Target P 1.0E + 00 1.0E - 01 Annual failure probability 1.0E - 02 Calibration results ; LRFD Safety class : Low Inspection : relative measure Inspection accuracy : StD ( d / t ) = 16 ...
Page 321
... Specified Minimum Yield Strength in longitudinal direction SMTS = Specified Minimum Tensile Strength in longitudinal direction • LIMIT PRESSURE FOR EXTERNAL OVERPRESSURE CONDITION : The limit external pressure ' p ' is to be calculated ...
... Specified Minimum Yield Strength in longitudinal direction SMTS = Specified Minimum Tensile Strength in longitudinal direction • LIMIT PRESSURE FOR EXTERNAL OVERPRESSURE CONDITION : The limit external pressure ' p ' is to be calculated ...
Contents
PIPELINE RELIABILITY AND LIMIT STATES DESIGN | 1 |
DESIGN OF PIPELINES AND RISERS | 5 |
OMAE99PIPE5019 | 21 |
Copyright | |
30 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied Arctic Engineering ASME assessment autoclave axial force bending buckling calculated capacity Conference On Offshore Copyright corrosion corrosion defect crack defined deformation dent depth Det Norske Veritas developed diameter discrete displacement vector effect equation failure modes failure probability Figure finite element finite element analysis fracture friction function fuzzy logic gasket geotechnical engineering GTAW hoop stress hot tap tee InSAR installation internal pressure jumper length Limit State Design load longitudinal MANAVGAT material maximum measured Mechanics and Arctic modal displacement neural networks node Offshore Mechanics operating pressure ovalisation parameters Petrobras pipe material pipe wall pipeline design Pipeline Systems plastic reliability riser risk run pipe saddle safety class seabed simulation SMAW SMYS specimens stinger strain stress Table Technology temperature tensile test scheme uprating valve wall thickness yield strength ας მთ მი მს