International Residential Code for One- and Two-family Dwellings |
From inside the book
Results 1-3 of 86
Page 67
... located in Seismic Design Categories D1 and D2 shall have a minimum vertical reinforcement of one No. 3 bar located a maximum of 4 feet ( 1220 mm ) on center in grouted cells . Foundation walls located in Seismic Design Categories D1 ...
... located in Seismic Design Categories D1 and D2 shall have a minimum vertical reinforcement of one No. 3 bar located a maximum of 4 feet ( 1220 mm ) on center in grouted cells . Foundation walls located in Seismic Design Categories D1 ...
Page 118
... Located at each end and at least every 25 feet on center but not less than 16 % of braced wall line . Located at each end and at least every 25 feet on center but not less than 16 % of braced wall line for Method 3 and 25 % of braced ...
... Located at each end and at least every 25 feet on center but not less than 16 % of braced wall line . Located at each end and at least every 25 feet on center but not less than 16 % of braced wall line for Method 3 and 25 % of braced ...
Page 317
... located in accordance with Sections M1804.2.5.1 through M1804.2.5.3 . The bottom of the vent terminal and air intake shall be located not less than 12 inches ( 305 mm ) above grade . M1804.2.5.1 Input 10,000 Btu / h or less . The vent ...
... located in accordance with Sections M1804.2.5.1 through M1804.2.5.3 . The bottom of the vent terminal and air intake shall be located not less than 12 inches ( 305 mm ) above grade . M1804.2.5.1 Input 10,000 Btu / h or less . The vent ...
Other editions - View all
International Residential Code for One- and Two-Family Dwellings: Turbo Tabs International Code Council No preview available - 2003 |
Common terms and phrases
12 inches accor accordance with Section accordance with Table air admittance valve appliance applied approved ASTM braced wall line braced wall panels ceiling joists clearance combustion air comply concrete conductors connected construction dead load diameter draft hood drain drainage ducts equipment exceed exterior walls FAN NAT FAN fastened feet FIGURE fireplace fixture floor flue furnace grade Ground snow load grout heaters height horizontal installed in accordance insulating concrete form insulation International Building Code joints joists kN/m² less LINTEL listed and labeled located manufacturer's installation instructions masonry material maximum metal mile per hour minimum nail NAT FAN NAT opening outlet permitted piping material pound per square pressure R-value reinforcement roof screws Seismic Design Categories sheathing slope Southern pine space square foot square inch studs thickness tion Type units valve vent connector venting system vertical wall studs wind speed Wood shingles wood structural panel