International Residential Code for One- and Two-family Dwellings |
From inside the book
Results 1-3 of 43
Page 352
... Valve approval . Shutoff valves shall be of an approved type . Shutoff valves shall be constructed of materials ... valve . Every meter shall be equipped with a shutoff valve located on the supply side of the meter . G2419.3 ( 409.3.2 ) ...
... Valve approval . Shutoff valves shall be of an approved type . Shutoff valves shall be constructed of materials ... valve . Every meter shall be equipped with a shutoff valve located on the supply side of the meter . G2419.3 ( 409.3.2 ) ...
Page 400
... Valves . Valves shall be installed in accordance with Sections P2903.9.1 through P2903.9.3 . P2903.9.1 Service valve . Each dwelling unit shall be pro- vided with an accessible main shutoff valve near the entrance of the water service . The ...
... Valves . Valves shall be installed in accordance with Sections P2903.9.1 through P2903.9.3 . P2903.9.1 Service valve . Each dwelling unit shall be pro- vided with an accessible main shutoff valve near the entrance of the water service . The ...
Page 411
... valve and a gate valve located on the discharge side of the check valve shall be installed in the pump or ejector discharge piping be- tween the pump or ejector and the drainage system . Access shall be provided to such valves . Such ...
... valve and a gate valve located on the discharge side of the check valve shall be installed in the pump or ejector discharge piping be- tween the pump or ejector and the drainage system . Access shall be provided to such valves . Such ...
Other editions - View all
International Residential Code for One- and Two-Family Dwellings: Turbo Tabs International Code Council No preview available - 2003 |
Common terms and phrases
12 inches accor accordance with Section accordance with Table air admittance valve appliance applied approved ASTM braced wall line braced wall panels ceiling joists clearance combustion air comply concrete conductors connected construction dead load diameter draft hood drain drainage ducts equipment exceed exterior walls FAN NAT FAN fastened feet FIGURE fireplace fixture floor flue furnace grade Ground snow load grout heaters height horizontal installed in accordance insulating concrete form insulation International Building Code joints joists kN/m² less LINTEL listed and labeled located manufacturer's installation instructions masonry material maximum metal mile per hour minimum nail NAT FAN NAT opening outlet permitted piping material pound per square pressure R-value reinforcement roof screws Seismic Design Categories sheathing slope Southern pine space square foot square inch studs thickness tion Type units valve vent connector venting system vertical wall studs wind speed Wood shingles wood structural panel