## Foundations of Colloid Science, Volume 2 |

### From inside the book

Results 1-3 of 53

Page 855

Room mn ) ) ( 14.4.1 ) n num where the form factors now only

Room mn ) ) ( 14.4.1 ) n num where the form factors now only

**depend**on the ... F. ( Q ) no longer**depends**on n , so that eqn ( 14.4.1 ) reduces to 19 ) = NF ...Page 943

The peak pressure , Pu , induced by the sound wave

The peak pressure , Pu , induced by the sound wave

**depends**on its intensity I ( in watts m- ? ) according to : P = ( 2u.pl ) 12 = + 1730 ( 1/2 for water ...Page 1010

measurements also

measurements also

**depends**on the postulation of a particular sort of constitutive ... In general the shearing stress and rate of shear will**depend**upon the ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

INTRODUCTION TO STATISTICAL MECHANICS | 675 |

ADSORPTION FROM SOLUTION | 709 |

THE ELECTROKINETIC EFFECTS | 786 |

Copyright | |

7 other sections not shown

### Other editions - View all

### Common terms and phrases

adsorbed adsorption applied approach approximation assumed average becomes behaviour bulk calculated Chapter charge Chem Colloid interface Sci colloidal component concentration constant correlation corresponding density depends described determined developed direction discussed dispersion distance double layer droplets effect electrical electrokinetic electrolyte emulsion energy equation equilibrium estimate et al example Exercise expression factor field film flow fluid force fraction function given gives groups important increases interaction interface involved ions limit liquid material measured microemulsion molecules Note observed obtained occur pair parameters particles phase positive possible potential present pressure problem procedure radius range reduces referred region result scattering Section separation shear rate shown solution specific spheres stability stress structure surface surface charge surface tension suspension temperature theory thin usually values viscosity volume zero