Uniform Building Code, Volume 3International Conference of Building Officials, 1994 - Building laws |
From inside the book
Results 1-3 of 17
Page 3-266
... brace shall lie in a straight line to avoid eccentric load- ings on fittings and fasteners . For longitudinal braces only , the brace shall be permitted to be connected to a tab welded to the pipe in conformance with 2-5.2 . The struc ...
... brace shall lie in a straight line to avoid eccentric load- ings on fittings and fasteners . For longitudinal braces only , the brace shall be permitted to be connected to a tab welded to the pipe in conformance with 2-5.2 . The struc ...
Page 3-272
... brace . Lateral braces may also act as longitudinal braces if they are within 24 in . ( 610 mm ) of the center line of the piping braced longitudinally . 4-5.4.3.5.8 * Sway bracing is not required for branch lines . Exception No. 1 ...
... brace . Lateral braces may also act as longitudinal braces if they are within 24 in . ( 610 mm ) of the center line of the piping braced longitudinally . 4-5.4.3.5.8 * Sway bracing is not required for branch lines . Exception No. 1 ...
Page 3-359
... braces should meet the piping at right angles , and longitudinal braces should be aligned with the piping . ( c ) Determine the total load tentatively applied to each brace in accordance with the examples shown in Figure A - 4-5.4.3.5.1 ...
... braces should meet the piping at right angles , and longitudinal braces should be aligned with the piping . ( c ) Determine the total load tentatively applied to each brace in accordance with the examples shown in Figure A - 4-5.4.3.5.1 ...
Contents
General Building Limitations | 3-1 |
Administrative Fire and LifeSafety and Field Inspection Provisions | 3-3 |
Chapter | 3-9 |
Copyright | |
102 other sections not shown
Other editions - View all
Common terms and phrases
accordance ANSI applied approved assembly ASTM authority having jurisdiction beams braces branch lines brick building official ceiling cement check valve classification combustible concrete masonry construction control valve curtain deck deflectors determined devices diameter dimensions distance door drain dry pipe valve duct edge equipment exceed Exception feet fire department connection fire test fire-resistance rating flange floor flow furnace grade gypsum hangers Hazard Occupancies heat horizontal hydrostatic test installed joints joist klers knot length less limited liquid limit listed load located material maximum minimum mortar nails NFPA noncombustible Obstruction opening operation percent permitted pipe system portland cement preaction pressure protection riser roof Screw SECTION side spaced specified sprinkler system sq ft standpipe system storage structural steel structural steel columns Table temperature test sample thermocouples tion tube Type U.B.C. Standard Uniform Building Code units vertical wall thickness water supply welding width wood