Uniform Building Code, Volume 3International Conference of Building Officials, 1994 - Building laws |
From inside the book
Results 1-3 of 90
Page 3-20
... spaced across the width of the unit . No more than four or less than two sections need be so instrum- ented in each representative span . Locate the groups of four thermocouples in representative loca- tions . Typical thermocouple ...
... spaced across the width of the unit . No more than four or less than two sections need be so instrum- ented in each representative span . Locate the groups of four thermocouples in representative loca- tions . Typical thermocouple ...
Page 3-36
... spaced not more than five times the face width of each board . Rows of nails at edges of core shall be about 1/2 inches ( 38 mm ) from each edge . Nails in vertical edge rows shall be placed not more than the face width of each board ...
... spaced not more than five times the face width of each board . Rows of nails at edges of core shall be about 1/2 inches ( 38 mm ) from each edge . Nails in vertical edge rows shall be placed not more than the face width of each board ...
Page 3-40
... spaced at intervals not exceeding 12 inches ( 304.8 mm ) and not more than 2 inches ( 50.8 mm ) from each end . Nails securing seams between molding strips and face sections shall be spaced at intervals not exceeding 3 inches ( 76.2 mm ) ...
... spaced at intervals not exceeding 12 inches ( 304.8 mm ) and not more than 2 inches ( 50.8 mm ) from each end . Nails securing seams between molding strips and face sections shall be spaced at intervals not exceeding 3 inches ( 76.2 mm ) ...
Contents
General Building Limitations | 3-1 |
Administrative Fire and LifeSafety and Field Inspection Provisions | 3-3 |
Chapter | 3-9 |
Copyright | |
102 other sections not shown
Other editions - View all
Common terms and phrases
accordance ANSI applied approved assembly ASTM authority having jurisdiction beams braces branch lines brick building official ceiling cement check valve classification combustible concrete masonry construction control valve curtain deck deflectors determined devices diameter dimensions distance door drain dry pipe valve duct edge equipment exceed Exception feet fire department connection fire test fire-resistance rating flange floor flow furnace grade gypsum hangers Hazard Occupancies heat horizontal hydrostatic test installed joints joist klers knot length less limited liquid limit listed load located material maximum minimum mortar nails NFPA noncombustible Obstruction opening operation percent permitted pipe system portland cement preaction pressure protection riser roof Screw SECTION side spaced specified sprinkler system sq ft standpipe system storage structural steel structural steel columns Table temperature test sample thermocouples tion tube Type U.B.C. Standard Uniform Building Code units vertical wall thickness water supply welding width wood