## MECHANICAL METALLURGY |

### From inside the book

Results 1-3 of 84

Page 13

wherc <rv = working stress, psi <r0 = yield strength, psi <r,, = tensile strength, psi

No =

strength The value assigned to the

wherc <rv = working stress, psi <r0 = yield strength, psi <r,, = tensile strength, psi

No =

**factor**of safety based on yield strength Nu =**factor**of safety based on tensilestrength The value assigned to the

**factor**of safety depends on an estimate of ...Page 311

The ratio of the maximum stress to the nominal stress is the theoretical stress-

concentration

computed from the theory of elasticity for simple geometries and can be

determined from ...

The ratio of the maximum stress to the nominal stress is the theoretical stress-

concentration

**factor**Kt. As was discussed in Sec. 2-13, values of Kt can becomputed from the theory of elasticity for simple geometries and can be

determined from ...

Page 439

In the early stages of a research project it is frequently important to determine

what are the important

importance of each of these

In the early stages of a research project it is frequently important to determine

what are the important

**factors**in the problem under study and what is the relativeimportance of each of these

**factors**. The use of a factorial design in place of the ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

Stress and Strain Relationships for Elastic Behavior | 17 |

Elements of the Theory of Plasticity | 54 |

Plastic Deformation of Single Crystals | 81 |

Copyright | |

19 other sections not shown

### Other editions - View all

### Common terms and phrases

alloys aluminum angle annealing ASTM axis behavior bending billet brittle fracture Burgers vector cent compressive constant crack creep rate decrease determined diameter direction dislocation line distribution drawing ductile edge dislocation effect elastic elongation equation extrusion factor failure fatigue limit flow curve flow stress force forging forming friction given grain boundaries hardness high-temperature increase indentation lattice length load longitudinal mandrel martensite material maximum measured mechanical metallurgical Metals Park method modulus notch obtained occurs orientation particles plastic deformation pressure principal stresses Proc produced properties punch quenched radius ratio recrystallization region relationship residual stresses rolling screw dislocations shear stress sheet shown in Fig shows single crystals slip plane Society for Metals specimen steel strain energy strain hardening strain rate stress-strain curve structure surface temper tensile strength tensile stress theory thickness tion torsion Trans transition temperature tube usually yield point yield strength yield stress