Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 5American Society of Mechanical Engineers, 1992 - Arctic regions |
From inside the book
Results 1-3 of 98
Page 62
... load at the stinger tip ( H ) required for pipelay , the average environmental load ( H ) due to wind and current , dynamic loads ( Hyn ) due to waves and wind gust , and move - up loads ( Hmove ) : H = Hpipe + Heav + Haya + Hmove Pipe ...
... load at the stinger tip ( H ) required for pipelay , the average environmental load ( H ) due to wind and current , dynamic loads ( Hyn ) due to waves and wind gust , and move - up loads ( Hmove ) : H = Hpipe + Heav + Haya + Hmove Pipe ...
Page 86
... loads ( or load effects ) multiplied by load factors that are normally greater than one , and on nominal resistances multiplied by resistance factors that are less than one . The basic requirement can be stated as : factored resistance ...
... loads ( or load effects ) multiplied by load factors that are normally greater than one , and on nominal resistances multiplied by resistance factors that are less than one . The basic requirement can be stated as : factored resistance ...
Page 244
... loads and load effects to be measured against the resistance and capacity models . Limit state functions or failure modes for the relevant load conditions and capacity models should be identified . The uncertainty analysis will then ...
... loads and load effects to be measured against the resistance and capacity models . Limit state functions or failure modes for the relevant load conditions and capacity models should be identified . The uncertainty analysis will then ...
Contents
OFFSHORE PIPELINE TECHNOLOGY | 53 |
CODESSTANDARDS AND REGULATIONS | 75 |
OFFSHORE MECHANICS AND ARCTIC ENGINEERING | 89 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
Alberta analysis applied Arctic assessment axial bending buckling buried pipelines calculated Canadian Standards Association coefficient construction corrosion crack criteria cylinder damage defects depth developed diameter displacement distribution effect elastic Engineering environmental equation equipment estimated evaluation failure probability fatigue finite element flow force fractile fracture fracture mechanics frequency frost heave frozen soil gas pipeline geometry hoop stress horizontal inspection installation interaction internal lift force Limit States Design load lognormal longitudinal maximum measured Mechanics meter methods offshore pipelines OMAE operation orifice orifice plate parameters permafrost pipe wall pipeline spans pipeline system Pipeline Technology ASME plastic predicted pressure ratio reliability S-N curve scour simulation SMYS solution specific standards steel strain structural Table Technology ASME 1992 temperature differential tensile tube bundle usage factor variable velocity profile vertical vibration volumetric flow rate vortex shedding wall thickness weld yield strength