Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 5American Society of Mechanical Engineers, 1992 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 124
... maximum " break - out " resistance for a given penetration give a good prediction of experimental results provided the relative density parameter in the equations is set to a particular fixed value independent of the actual soil ...
... maximum " break - out " resistance for a given penetration give a good prediction of experimental results provided the relative density parameter in the equations is set to a particular fixed value independent of the actual soil ...
Page 173
... maximum stress ranges during vibration are between 3.4 and 6.8 ksi for the 6 - inch through 10 - inch gas pipelines . Thus , if one of these systems has a weld located near a location of maximum stress along the pipeline , and if this ...
... maximum stress ranges during vibration are between 3.4 and 6.8 ksi for the 6 - inch through 10 - inch gas pipelines . Thus , if one of these systems has a weld located near a location of maximum stress along the pipeline , and if this ...
Page 228
... Maximum SF - 1.77 Minimum SF - 0.74 Standard Deviation = 0.20 ם . Trend Line 45 55 65 75 Burst Pressure / Flow ... maximum hoop membrane stress in the patch divided by the nominal hoop stress in a pipe without a corroded region . The ...
... Maximum SF - 1.77 Minimum SF - 0.74 Standard Deviation = 0.20 ם . Trend Line 45 55 65 75 Burst Pressure / Flow ... maximum hoop membrane stress in the patch divided by the nominal hoop stress in a pipe without a corroded region . The ...
Contents
OFFSHORE PIPELINE TECHNOLOGY | 53 |
CODESSTANDARDS AND REGULATIONS | 75 |
OFFSHORE MECHANICS AND ARCTIC ENGINEERING | 89 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
Alberta analysis applied Arctic assessment axial bending buckling buried pipelines calculated Canadian Standards Association coefficient construction corrosion crack criteria cylinder damage defects depth developed diameter displacement distribution effect elastic Engineering environmental equation equipment estimated evaluation failure probability fatigue finite element flow force fractile fracture fracture mechanics frequency frost heave frozen soil gas pipeline geometry hoop stress horizontal inspection installation interaction internal lift force Limit States Design load lognormal longitudinal maximum measured Mechanics meter methods offshore pipelines OMAE operation orifice orifice plate parameters permafrost pipe wall pipeline spans pipeline system Pipeline Technology ASME plastic predicted pressure ratio reliability S-N curve scour simulation SMYS solution specific standards steel strain structural Table Technology ASME 1992 temperature differential tensile tube bundle usage factor variable velocity profile vertical vibration volumetric flow rate vortex shedding wall thickness weld yield strength