Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volumes 5-6; Volume 8, Parts 5-6American Society of Mechanical Engineers, 1989 - Arctic regions |
From inside the book
Results 1-3 of 67
Page 56
... ratios are known from the 1st phase . In other words , the 2nd phase will determine the blending ratios , flow rates and the days the system will be operating under each ratio and flow rate . Assume there Suppose there are k kinds of ...
... ratios are known from the 1st phase . In other words , the 2nd phase will determine the blending ratios , flow rates and the days the system will be operating under each ratio and flow rate . Assume there Suppose there are k kinds of ...
Page 99
... ratio - 200 mm and 400 mm · - fine , medium , rough ( 10-5 to 5x10-2 ) fine , medium , rough ( 10-3 to 5x10-2 ) · 0.69 m / sec Steady Current Regular Waves 0.5-3.6 0.3 - 2.4 3 - 160 0 -1.6 Irregular Waves 0.7 2.5 10 - 70 0- 1.2 Test ...
... ratio - 200 mm and 400 mm · - fine , medium , rough ( 10-5 to 5x10-2 ) fine , medium , rough ( 10-3 to 5x10-2 ) · 0.69 m / sec Steady Current Regular Waves 0.5-3.6 0.3 - 2.4 3 - 160 0 -1.6 Irregular Waves 0.7 2.5 10 - 70 0- 1.2 Test ...
Page 96
... ratio of the area of the horizontal wings to the longitudinal projected area of the fuselage P1 and the ratio of the area of the forward wing to that of the rear wing P2 under some parameters and constrained conditions . The parameters ...
... ratio of the area of the horizontal wings to the longitudinal projected area of the fuselage P1 and the ratio of the area of the forward wing to that of the rear wing P2 under some parameters and constrained conditions . The parameters ...
Contents
PIPELINE DESIGN AND OPERATIONS | 1 |
PIPELINE INDUSTRY OUTLOOK 89 | 69 |
PIPELINE FORCES DYNAMICS AND STABILITY I | 95 |
Copyright | |
17 other sections not shown
Other editions - View all
Common terms and phrases
amplitude analysis applied Arctic Engineering axial base metal bending Buckle length buckling bundle calculated coefficient compressor Conference on Offshore corrosion crack curvature deformation developed diameter displacement ductile effect Eighth International Conference electrodes equation explosive welding failure flaw flow rate gas turbine geometry heat horizontal hydrodynamic hydrodynamic forces hydrogen inertial installation laboratory length lift force line pipe liquid load maximum measured Mechanics and Arctic meters method monitoring natural burial Offshore Mechanics Offshore Technology Conference operation parameters predicted present pressure problem procedure ratio reheated reliability repair resistance response rockdumps sand SAW metal scour depth seabed shown in Figure simulation Snøhvit soft zone soil Sørøya sour gas span Statoil steel stress structural submarine pipelines submerged arc welding Sumer surface Table Technology temperature tion tool trench velocity vertical vibration viscometer viscosity vortex vortex shedding wave