Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 54
Page 64
The welding conditions and arc - energy of the weld passes following the first pass were selected specifically to obtain a grain coarsened HAZ at the CTOD test location that was sub - critically reheated .
The welding conditions and arc - energy of the weld passes following the first pass were selected specifically to obtain a grain coarsened HAZ at the CTOD test location that was sub - critically reheated .
Page 78
10 Distributions of microstructures and Charpy absorbed energy levels on crack fronts of weld HAZs for steels TM1 and NM . The bar charts indicating the microstructures are the same as those expressed in Fig .
10 Distributions of microstructures and Charpy absorbed energy levels on crack fronts of weld HAZs for steels TM1 and NM . The bar charts indicating the microstructures are the same as those expressed in Fig .
Page 200
According to linear elasticity , the energy absorbed in the pad is linearly proportional to the square of stress . ... equivalent stress to compare the strain energy absorption for different pads , under the condition of sustaining the ...
According to linear elasticity , the energy absorbed in the pad is linearly proportional to the square of stress . ... equivalent stress to compare the strain energy absorption for different pads , under the condition of sustaining the ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |