Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 29
Page 77
Fig.9 Distributions of microstructures along crack fronts and postulated locations of cleavage crack initiations for ... microstructures along the crack front , in particular at the point of fracture initiation , were identified for all ...
Fig.9 Distributions of microstructures along crack fronts and postulated locations of cleavage crack initiations for ... microstructures along the crack front , in particular at the point of fracture initiation , were identified for all ...
Page 78
The bar charts indicating the microstructures are the same as those expressed in Fig . 9 and the symbols " V " point the locations of the cleavage fracture initiation . THE UNIVERSITY OF MICHIGAN LIBRARIES 20 WELDING AND PROPERTIES OF.
The bar charts indicating the microstructures are the same as those expressed in Fig . 9 and the symbols " V " point the locations of the cleavage fracture initiation . THE UNIVERSITY OF MICHIGAN LIBRARIES 20 WELDING AND PROPERTIES OF.
Page 113
Fatigue precrack Fracture surface Cut Fracture initiation point Cut Cut Polishing & Etching А in initiation points of cleavage fracture , determined by the fractographic observation , were also plotted by the symbols " V " and " V " .
Fatigue precrack Fracture surface Cut Fracture initiation point Cut Cut Polishing & Etching А in initiation points of cleavage fracture , determined by the fractographic observation , were also plotted by the symbols " V " and " V " .
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |