Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 62
Page 223
In the steelmaking process , it is necessary to lower the sulfur and oxygen contents in order to ensure resistance to lamellar tearing . In addition to this , it is necessary to lower the hydrogen content and reduce segregation in order ...
In the steelmaking process , it is necessary to lower the sulfur and oxygen contents in order to ensure resistance to lamellar tearing . In addition to this , it is necessary to lower the hydrogen content and reduce segregation in order ...
Page 267
Therefore , not only sound pressure pi but also .reflection factor ri of reflected wave decrease with reflections , which results in the lower amplitude of reflected wave than the surface echo . At a water path of 21 mm , on the other ...
Therefore , not only sound pressure pi but also .reflection factor ri of reflected wave decrease with reflections , which results in the lower amplitude of reflected wave than the surface echo . At a water path of 21 mm , on the other ...
Page 301
Between the lower most riser joint and the lower riser connector the tapered joint is located . At this location all of the combined effects of the flexible pipe drag , riser restraint system , riser buoyancy and environmental induced ...
Between the lower most riser joint and the lower riser connector the tapered joint is located . At this location all of the combined effects of the flexible pipe drag , riser restraint system , riser buoyancy and environmental induced ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |