Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 208
For brittlepropagation - plate of 1200mm in width , conventional structural steels with 500 MP a - class tensile strength ( HT500 ) were applied in most of cases . Figure 5 summarizes the test results and compares them with the steel's ...
For brittlepropagation - plate of 1200mm in width , conventional structural steels with 500 MP a - class tensile strength ( HT500 ) were applied in most of cases . Figure 5 summarizes the test results and compares them with the steel's ...
Page 209
Table 2 Mechanical properties of newly developed steel plate Tensile Test ( 1 ) Charpy Impact Test ( 2 ) Thick . Y.P. T.S. El . VE - 51 ° C Grade vTrs ( mm ) ( MPa ) ( MPa ) ( % ) ( J ) ( ° C ) KL33 16 363 451 30 340 -93 ( 1 ) NK U1 ...
Table 2 Mechanical properties of newly developed steel plate Tensile Test ( 1 ) Charpy Impact Test ( 2 ) Thick . Y.P. T.S. El . VE - 51 ° C Grade vTrs ( mm ) ( MPa ) ( MPa ) ( % ) ( J ) ( ° C ) KL33 16 363 451 30 340 -93 ( 1 ) NK U1 ...
Page 221
1991 OMAE - Volume III - A , Materials Engineering ASME – 1991 H. Nakao Plate Technical Division Nippon Steel Corporation Tokyo , Japan K. Hattori and H. Muraoka Quality Control Division Nagoya Works Nippon Steel Corporation Aichi - Ken ...
1991 OMAE - Volume III - A , Materials Engineering ASME – 1991 H. Nakao Plate Technical Division Nippon Steel Corporation Tokyo , Japan K. Hattori and H. Muraoka Quality Control Division Nagoya Works Nippon Steel Corporation Aichi - Ken ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |