Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 52
Page 26
Thus , one obtains information about strains in certain discrete points , although it is possible to obtain the global strain field on a plate surface by use of optical methods . In all experimental methods , the strains measured are ...
Thus , one obtains information about strains in certain discrete points , although it is possible to obtain the global strain field on a plate surface by use of optical methods . In all experimental methods , the strains measured are ...
Page 85
In this case results for different thicknesses have to be taken separately , but it is possible to include the predictive lines from the TWI scheme for avoidance of hydrogen cracking in C - Mn steels ( 9 ) . These were generated using ...
In this case results for different thicknesses have to be taken separately , but it is possible to include the predictive lines from the TWI scheme for avoidance of hydrogen cracking in C - Mn steels ( 9 ) . These were generated using ...
Page 191
Since the camera optic was also used as front window for the pressure housing , it was not possible to achieve a helium proof system . During operation under hyperbaric conditions helium diffuses into the housing increasing the intern ...
Since the camera optic was also used as front window for the pressure housing , it was not possible to achieve a helium proof system . During operation under hyperbaric conditions helium diffuses into the housing increasing the intern ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |